First, find the main reason for moldy: Leather skin collagen protein, processed products used in processing raw materials containing grease, tannin extracts and other ingredients, these are source of nutrition for the growth of mold in. Moreover, the breathable pores of the leather to enhance the moisture absorption , therefore the leather processing, storage, leather finished the process of preservation and use of bacteria and fungi is very invasive and easy to breed to breed, leading to the decay of bare skin, the vibram five fingers sale code surface mildew. Mild can be removed, but the leather has lost its luster, mildew makes leather embrittlement of the grain, reducing the physical properties of leather, affecting vibram five fingers sizing sale and use of performance. First, temperature and humid, mold growth and to provide a favorable environment, in general the most suitable mold temperature of 22 to 33. PH value of 4.0-6.0, moisture regain higher. Second, some shoe companies in the product is not completely dry after sealed package. Third, the limited common desiccant drying moisture can not be curbed the growth of mold. Second, our shoe factory how to mold? A stacked leather warehouse ventilation, keep the ground and stacked plate isolation, control moisture, high-grade calfskin, lambskin, anti-fur hygroscopicity strong, but also to control. Second, the different types of leather partition </ A> stacked. The warehouse staff should regularly inspect and found that adverse dealt with promptly. , Processing each section in passing with a touch-ban raw water, touch the water is absolutely moldy. Five, set the oven or heat-setting time, to maintain the efficiency of heat setting. Six, the final and decisive measures (a few days ago, there are three): A spray fungicide, add the right amount of desiccant to maintain the quality of the shoes. B, UV light irradiation, and finally came alive again in the right amount of desiccant. Directly into the mildew, mold piece. (Placement of the mold piece should also pay attention to, and must be affixed to any of the corner by the shoebox, rather than attached to the middle in order to better play its effectiveness) the mold should be an important process in the leather processing prior to packaging , not to temporarily relax the impact of the quality of the mold of the shoe-making enterprises should choose mildew, mold piece or mildew resistant finish and then put desiccant.